Wear Testing of High-alloy Carbon Steel Used in Mining Tools

Wear is a commonly occurring degradation mechanism for materials and components in the rock drilling industry. The wear can occur by either abrasion or adhesive wear. Further corrosion and presence of water or other lubricating fluids with or without particles may influence the behavior.

Which mechanism, or mechanisms, and under which conditions it occurs, as well as the relative wear rate is dependent on the actual operating conditions for the component.

In the present study, commonly available and general test methods for wear on high-alloy carbon steel has been analyzed. The project has been carried out through literature reviews and study visits at the tribology laboratory at KTH and at the Angstroms laboratory at Uppsala University. The present study indicates that it is difficult to suggest a feasible test method that is possible to use for all different situations of the wear that may occur.

A test adapted to the actual situation is required to achieve a proper wear rate comparable to the wear rate in a real application.  According to the requirements from Ovako AB, a test that is general, cost effective and can be used when developing steel with higher wear-resistance, following wear testing methods has been compared: a pin-on-disk apparatus, a dry/wet sand/rubber wheel, a dry/wet sand/steel wheel, a tumbling mill, a particle erosion rig, a solid particle impingement using gas jets and a grinding machine.

The tumbling mill, the grinder and the “Standard Test Method for Wear Testing with a Pin-On- Disk Apparatus” correspond to the requirements best. Ovako AB is recommended to continue the work with these testing methods.
Source: KTH
Author: Olsson, Sara | Efsing, Linn

Download Project


Leave a Reply

Your email address will not be published. Required fields are marked *

× eight = thirty two